Panther (USA) brand.
No awkward steering from the stern.
Comes complete with two quick disconnect ball joint assemblies.
For engines 66cm (26�) apart centre-centre.� Reducible to 29cm (11.4�) by shortening (e.g. use a hacksaw) the included threaded connector rod (61cm/24� long).�
Brackets & clamps for attaching the ball joints to each motor are included.
Suitable for trolling/auxiliary motors up to 25hp.

3/8"-24 thread on rod & stud.�Drill a 10mm hole to mount the ball joint stud.

Stainless steel & chromed bronze construction for salt water use.

Installation note: it is very important that the quick release ball joints are not binding (and the�tie bar�is not striking any part of the boat or�a engine)�when the main engine steering is turned through its whole range.� Check this by turning the steering slowly through its whole�range while checking that the tie bar assembly still has movement (play) in it.� If not, stop and adjust the installation, then recheck e.g. reshape the tie bar.